Filter By:
- Bar Ends (16)
- BMX (62)
- Bottom Brackets (247)
- Brakes/Levers/Pads (728)
- Cables (221)
- Cassettes/Freewheels (150)
- Chainrings (279)
- Chains (158)
- Show More Categories
- Cranksets (318)
- Derailleurs (186)
- Forks (176)
- Groups (30)
- Handlebar Grips/Tape (382)
- Handlebars (283)
- Headsets (192)
- Pedals (415)
- Saddles/Pads (384)
- Seatposts (110)
- Shift/Brake Combinations (74)
- Shifters (138)
- Shocks (25)
- Stems (177)
- Other (1911)
- Show Fewer Categories
- Show More Brands
- Show Fewer Brands
- Show More Sizes
- Show Fewer Sizes
- Show More Model Years
- Show Fewer Model Years
Parts
$2.00
This is a replacement Brake Hose Cover for the Lever End of Shimano BH90-SBM, BH90-SB levers.
- Covers brake hose fitting at the brake lever
$2.09
Replace the top bearing in your YST8300 headset with these caged ball bearings.
$2.09
- Routes cables underneath the bottom bracket
- Will not rust or corrode
$2.42
Parts for the service of the seal and restore the smooth cycling of KS dropper posts.
$2.50
Replacement piston and seals for Hope disc brake calipers.
$2.50
Replacement piston and seals for Hope disc brake calipers.
$2.50
Use to create your desired chain length in single-speed applications. Only one half link is needed.
- Non-reusable
- Width: 9.4 mm
- Drivetrain Speeds: 1
- Color: Black
- Chain Compatibility: Shimano , SRAM , Campagnolo , Connex , KMC
$2.50
The Gyro G3 upper top plate is designed for use with the G3 detangler.
$2.54
Race Face aluminum chainring bolts for inner chainrings. Includes four 12.5mm bolts.
$2.59
- Model: Derailleur Bolt & Nut
- Compatibility: Mounts rear bracket to frame
$2.75
- Half-link connector allows you to add or subtract half of one link (1/2 inch) from the chain in order to optimize chain tension
- Uses standard chain pin connector and tool
$2.99
Air Spring Volume Reduction Kit
- Cane Creel Kitsuma Air 1250^3 Negative Volume Reducer
$2.99
- For Race Face 30mm Cinch System cranks only
- Allows switching crank arms between bikes, such as a FatBike and an XC MTB
- Use RF-2999 for 8mm to 16mm hex wrench adapter to remove spindle